Advertisement
Quick Links
IMPORTANT:
PlEAsE NOTE: whEN yOu OPEN ThE cARTON, cAREfully chEck ThE uNIT ANd
MAkE suRE ThERE Is NO dAMAgE. If yOu hAvE ANy PROBlEMs wITh ThE uNIT,
wITh hOw ThE vARIOus fuNcTIONs wORk, OR hAvE dAMAgEd OR MIssINg PARTs
PlEAsE cAll 1-800-459-4409 (MONdAy TO fRIdAy, 8:30AM TO 5:00PM, EsT)
IMMEdIATEly fOR sERvIcE.
NOTE: dO NOT RETuRN uNIT TO ThE sTORE BEfORE cAllINg ThE TOll fREE
NuMBER. dO NOT dIsPOsE Of yOuR cARTON uNTIl yOu ARE cOMPlETEly
sATIsfIEd wITh yOuR NEw fIREPlAcE hEATER.
NOTE: Light bulbs may become loose during shipping. If the flame effect is dim or does
not work, please check that light bulb or bulbs are finger tight in socket. See instructions for
replacing bulb or bulbs. Please do not return the sample to the store before checking light bulbs.
NOTE: The electric fireplace heater may emit a slight harmless odor when first turned on.
This is caused by activating the internal heater components for the first time and should not
occur again.
iNStrUctiON MANUAl
ATTENTION:
1. Find a location for the fireplace heater that is protected from direct sunlight.
2. Do not plug the unit into the power outlet before reading all instructions.
iMPOrtANt SAFEtY iNStrUctiONS
whEN usINg ElEcTRIcAl APPlIANcEs, BAsIc PREcAuTIONs shOuld AlwAys
BE fOllOwEd TO REducE ThE RIsk Of fIRE, ElEcTRIc shOck, ANd INJuRy TO
PERsONs, INcludINg ThE fOllOwINg:
1) Read all instructions before using this electric fireplace heater.
2) This electric fireplace heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. The grill directly in front of the heater outlet becomes
hot during heater operation. keep combustible materials, such as furniture,
pillows, bedding, papers, clothes, and curtains at least 3 feet (0.9 m) away
from the front of the unit and keep them away from the sides and rear.
3) Extreme caution is necessary when any heater is used by or near children
or individuals with disabilities and whenever the fireplace is left operating
and unattended.
4) Always unplug fireplace when not in use.
5) do not operate any electric fireplace with a damaged cord or plug or after
the heater malfunctions, has been dropped or damaged in any manner.
6) do not use outdoors.
7) This electric fireplace heater is not intended for use in bathrooms, laundry
areas and similar indoor locations. Never locate heater where it may fall into a
bathtub or other water container.
8) do not run cord under carpeting. do not cover cord with throw rugs, runners, or
similar coverings. Arrange cord away from traffic area and where it will not be
tripped over.
9) To disconnect fireplace, turn controls to off, then remove plug from outlet.
10) connect to properly grounded outlets only.
11) do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or fire, or damage the heater.
ElEctric FirEPlAcE
HEAtEr
Model: MM420-55BEP
12) To prevent a possible fire, do not block air intakes or exhaust in any manner.
do not use on soft surfaces, like a bed, where openings may become blocked.
13) A heater has hot and arcing or sparking parts inside. do not use it in areas
where gasoline, paint, or flammable liquids are used or stored.
14) use this fireplace heater only as described in this manual. Any other use not
recommended by the manufacturer may cause fire, electric shock, or injury
to persons.
15) Avoid the use of an extension cord because the extension cord may overheat
and cause a risk of fire. however, if you have to use an extension cord, the cord
shall be No.14 Awg minimum size and rated not less than 1875 watts.
16) do not plug this product into a receptacle controlled by a wall switch
or dimmer.
17) when storing or transporting the unit and cord, keep in a dry place,
free from excessive vibration and store so as to avoid damage.
SAVE tHESE iNStrUctiONS FOr FUtUrE USE.
cAuTION:
If yOu usE ThIs hEATER IN cONJuNcTION wITh A ThERMAl cONTROl, A PROgRAM
cONTROllER, A TIMER OR ANy OThER dEvIcE ThAT swITchEs ThE hEATER ON
AuTOMATIcAlly, REMEMBER TO OBsERvE All sAfETy wARNINgs AT All TIMEs.
ThE fIREPlAcE hEATER hAs sAfETy OvERhEAT PROTEcTION. If ThE OvERhEAT
PROTEcTION TRIPs, swITch Off All swITchEs ANd wAIT APPROxIMATEly 5–10
MINuTEs. IT shOuld REsET AuTOMATIcAlly ONcE ThE uNIT cOOls dOwN.
wARNINg:
PROcEduREs ANd TEchNIquEs, If NOT cAREfully fOllOwEd, wIll REsulT IN
dAMAgE TO ThE EquIPMENT, ANd wIll ExPOsE ThE usER TO ThE RIsk Of sERIOus
INJuRy, IllNEss OR dEATh.
ThIs ElEcTRIc fIREPlAcE hEATER Is fOR usE ON 120 vOlTs. ThE cORd hAs A
Plug As shOwN AT A IN IllusTRATION BElOw. AN AdAPTER As shOwN AT c Is
AvAIlABlE fOR cONNEcTINg ThREE-BlAdE gROuNdINg-TyPE Plugs TO TwO-slOT
REcEPTAclEs. ThE gREEN gROuNdINg Plug ExTENdINg fROM ThE AdAPTER MusT
BE cONNEcTEd TO A PERMANENT gROuNd such As A PROPERly gROuNdEd OuTlET
BOx. ThE AdAPTER shOuld NOT BE usEd If A ThREE-slOT gROuNdEd REcEPTAclE
Is AvAIlABlE.
A 15 AMP cIRcuIT Is REquIREd TO OPERATE ThIs hEATER. If ThE BREAkER TRIPs
whEN ThE hEATER Is usEd, yOu MAy NEEd TO MOvE ThE hEATER TO ANOThER
lOcATION OR uNPlug OThER APPlIANcEs ThAT ARE ON ThE sAME cIRcuIT. If yOu
REquIRE AN ExTENsION cORd, usE ONE ThAT Is RATEd AT 1875 wATTs.
1
Advertisement
Related Manuals for Quality Craft MM420-55BEP
Summary of Contents for Quality Craft MM420-55BEP
- Page 1 ElEctric FirEPlAcE HEAtEr Model: MM420-55BEP IMPORTANT: 12) To prevent a possible fire, do not block air intakes or exhaust in any manner. do not use on soft surfaces, like a bed, where openings may become blocked. PlEAsE NOTE: whEN yOu OPEN ThE cARTON, cAREfully chEck ThE uNIT ANd MAkE suRE ThERE Is NO dAMAgE.
- Page 2 PArtS liSt: Fireplace insert...................... 1 A) Top panel ......................1 B) Back centre panel .................... 1 C) Middle panel ....................1 D) Base panel ...................... 1 E) Shelves ......................4 F) Left side panel ....................1 G) Right side panel ....................1 H) Left front panel ....................
- Page 3 Step 2: Attach 4 door hinges [Tb] to panels H and I with 12 mounting screws [Ua] as Step 4: Attach 16 shelf supports [S] to panels F, G, J and K as shown in Fig. D. shown in Fig. B. Fig.
- Page 4 Step 6: Attach panel C to panels J and K with 4 KD screws [W] as shown in Fig. F. Step 8: Slide panels L into the channels in the unit from above as shown in Fig. H. Fig. F BAck Step 7: Attach panels F and G to base panel D with 4 KD screws [W].
- Page 5 Step 10: Attach panel A to the unit as shown in Fig. J with 8 KD screws [W]. Step 12: Insert 4 shelves [E] as shown in Fig. L. fRONT Fig. l fRONT Fig. J Step 13: Attach 2 metal plates [Td] to left and right door [M and N] with 4 mounting screws [Ua].
-
Page 6: Operation
Step 14: Attach left and right door to panels F and G with 12 mounting screws [Ua]. See Fig. N. Step 16: Once the insert is in place, attach 2 L – mounting brackets [U] with 2 short KD screws [V] onto base panel [D]. -
Page 7: Maintenance
OPErAtiON BY tHE cONtrOl PANEl rEPlAciNG tHE FlAME EFFEct liGHt AND lOG-SEt liGHt BUlBS The controls are located behind the 2 front covers at the top right and left corners of the insert and can be accessed by gently pushing the bottom of the covers. Step 1: Remove the 2 screws on the front of the fireplace and open the glass window. - Page 8 rEPAirS OPTION 2: Use the small L-brackets and screws. If any problems are found with the original parts during mantel assembly – such 1. Place the small L-bracket to the unit and mark the drill holes on the mantel, as shown in as if the panels cannot be installed with the plastic connector –...
-
Page 9: Warranty Claim Procedure
This warranty is void, if in the opinion of Quality Craft, the unit has been tampered with, altered, misused, damaged, abused or used with the wrong power source. Light bulbs are not covered by this warranty.