Remote Suction
Hose Setup
(optional)
Recommended for
Start
medium to large jobs
Note: A 75% duty cycle is recommended when
spraying with the remote suction hoses. For
example, trigger the gun for 15 seconds, and
then allow the gun to remain idle (untriggered)
for 5 seconds.
ImpoRTANT: Avoid running the container
dry. An empty container will allow air to
get sucked into the sprayer, which leads to
globbing and spitting.
ImpoRTANT: Always make sure the tip nut
is tightened securely prior to spraying.
Note: The Low Cup Level Indicator (if
equipped, see page 8) are not applicable when
using the remote suction hoses.
English
1
1. Remove the cup -
See steps 1-3, previous page.
3
3. Attach the housing to the bottom of the
sprayer as shown.
Rotate the housing until it clicks into place.
6
2
2. Twist and remove the suction tube and
filter assembly.
4
4. Attach lid to paint container.
Push hoses through the holes in the lid
and down to the bottom of the material
container.