WAGNER Power Painter Max Owner's Manual page 14

Cleanup
(remote suction
hoses / backpack kit)
You will need:
Start
• Waste container
• Cleaner nozzle
• Warm soapy water if you sprayed latex
materials
• Mineral spirits if you sprayed oil-based
materials
make sure you clean the sprayer in a
well-ventilated area whenever
cleaning with flammable solvents.
The sprayer contains electrical parts.
Do NoT submerge the sprayer into
any liquids.
4
4. Disassemble the remote suction set
housing.
Clean all parts by hand using the
cleaning brush and the appropriate
cleaning solution.
Reassemble.
English
1
1. Unplug the sprayer.
Remove the remote suction set from the
material container / backpack assembly
and submerge into a container of the
solvent appropriate to the type of material
you sprayed.
5
Note: If you used the 5. Thread the cleaner
backpack kit, be sure nozzle onto a garden
to clean the suction hose.
tube and the inside of
the backpack by hand
using the appropriate
cleaning solution.
2
2. Plug in the sprayer.
Squeeze the trigger and
spray into a waste container
until the cleaning solution
comes through the sprayer
for a couple of minutes.
LATEx MATERIALS ONLY
6
6. Insert nozzle into one of
the remote suction hoses.
Place the other end of
the hose into a waste
container.
Turn on the water and
flush the hose until clean.
Repeat for the other
hose.
14
3
3. Unplug the sprayer.
Remove the remote suction
set housing from the sprayer.
Remove smaller return hose
from suction set housing.
7
7. Reattach the smaller
return hose to the dual
hose fitting.
Follow steps 4-10 in
Cleanup - Cup mode
(page 12).