Lubrication Components: Oil Filter Support - MV Agusta BRUTALE 910 S Workshop Manual

Engine
LUBRICATION COMPONENTS:
OIL FILTER SUPPORT
Reassembling
B
Clean all the surfaces accurately and check the seal
rings on the oil filter support screw as well as the O-
rings for wear; substitute them, if necessary.
Grease both the seal rings and the O-ring and position
them in their seats respectively, as shown in the figure.
Position the filter support on the base; as per guiding
and centering it refer to the special screw (1) for fixing
the oil cooler union plate placed on top left.
1
Once the support has been positioned, tighten the oil
filter support screw to a clamping torque of 40 Nm.
Assemble the short end of the oil filter union by
applying medium thread blocker (Loctite 243) and tigh-
tening to a clamping torque of 30 Nm.
40 N•m
- 87 -