Removing And Installing Individual Rear Seat - Audi A8 2003 Workshop Manual

3.4

Removing and installing individual rear seat

1 - Bolt
❑ Tightening torque 55
Nm
2 - Tab
3 - Individual rear seat
♦ Removing
– Remove the seat pan
⇒ page 342 .
– Unplug the connectors
-7-, -8-, -9- and -10-.
– Detach the wiring har‐
ness -13- from the body.
– Raise the tab -11- and
unscrew the bolt -12-.
– Raise the tab -14- and
unscrew the bolt -15-.
– Pull the tab -2- aside
and unscrew the bolt
-1-.
– Open the webbing guide
-5- at the clip -6-.
– Thread the webbing -4-
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
out of the guide -5-.
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
– Unscrew the bolt at the
with respect to the correctness of information in this document. Copyright by AUDI AG.
anchorage point of the
webbing -4-
⇒ page 358 .
– Pull the seat frame for‐
wards until the backrest
slides out of its guide.
– Lift the individual rear
seat -3- out of the vehi‐
cle.
♦ Installing
– Install the individual rear
seat -3- in the reverse
order of removal.
– Make sure the individual rear seat -3- engages on the left and right at the sliders in the guides in the
body.
4 - Webbing
5 - Webbing guide
6 - Clip
7 - Connector
8 - Connector
9 - Connector
10 - Connector
11 - Tab
12 - Bolt
❑ Tightening torque 55 Nm
General body repairs, interior - Edition 07.2011
3. Electrically operated individual rear seats
Audi A8 2003 ➤
343