Winnebago Suncruiser 33V Operator's Manual page 73

Water Pump Access Panel
(typical)
Water Pump (typical)
Pump Strainer
The pump is equipped with a cleanable
strainer to capture any possible tank borne
particles that could damage pump components.
NOTE: We recommend that you check and clean
this strainer after each tankful of water
during the first few uses of the water
pump system. Thereafter, remember to
check it at least yearly, such as during
winterization procedures.
Unscrew bowl and remove to clean strainer
Water Pump Strainer
To Clean Pump Strainer
Be sure all water pump switches are OFF.
• Twist the inlet cap (bowl) counterclockwise to
unscrew from the strainer assembly.
• Remove the bowl and pull the strainer screen
out of the bowl to tap out any particles and
rinse clean.
• Insert the strainer screen back into the bowl,
then screw the bowl back onto the strainer
assembly.
NOTE: You must also empty the strainer when
winterizing your coach to avoid water
freezing and cracking the strainer bowl.
Water Pump Switch
Water pump switches are located on the
Systems Monitor Panel and in the utility
compartment. While the switch is in the "ON"
position, the pump will automatically supply
water pressure as it is needed. It is recommended
that the pump switch be turned off whenever you
are away from the vehicle or not using the water
system. A slow leak in a faucet could drain the
water system and discharge the coach battery.
Initial Water Line Priming
1. Make sure that all water drain valves are
closed, including water heater valve.
2. Turn water pump switch to "OFF" position.
3. Fill water tank.
4. Open all faucets, hot and cold.
5. Turn on pump switch.
SECTION 7
PLUMBING
7-3