Winnebago Suncruiser 33V Operator's Manual page 44

SECTION 4
APPLIANCES & SYSTEMS
actually be some fluid left in the tank. However,
when the indicator reads FULL, the tank is
actually full.
Tank Capacities
See "Tank Capacities" in Section 1.
LP Gas Level
Press and hold the "Levels Test" switch to
show approximate LP tank level.
The LP level is registered by a sending unit on
the tank. The gauge mounted on the side of the
tank will give a more accurate indication of
actual tank level if needed.
Water Pump Switch
When use of the self-contained water system
is desired, turn the "Water Pump" switch on. The
"Pump On" light will illuminate when the pump
switch is on and the system is operable. Water
will be available as soon as a faucet is opened.
Refer to "Water Pump" for additional
information on the water pump and initial start-
up. (There is also a pump switch in the utility
compartment on the outside of the coach.)
4-4
Water Pump
Switch
Battery Voltage Meter
Push the "Levels Test" button to check the
level of charge (voltage) in the 12-volt coach
battery.
To get an accurate reading;
1. Both the chassis engine and the auxiliary
generator engine must be shut off.
2. An interior light should be turned on to
provide a small load which draws off the
battery surface charge.
The LCD display will show the current battery
voltage to the nearest tenth of a volt.
• A 12-volt battery typically registers anywhere
from 12.5V to 13V when adequately charged.
• Voltage below 12V indicates a discharged
condition; 11.5V or less is dead.
• Voltage above 13V typically indicates that the
battery is being charged by the converter
charging section.