Appendix 3 - Calibration Procedures - Bowflex TC5300 Service Manual

Hide thumbs Also See for TC5300:

Assembly manual & owner's manual (76 pages)

Table Of Contents

Table of Contents

calibration Procedure

You will need to re-calibrate the TreadClimber

any electronic component on the machine.

Do NoT STEP oN THE BELTS DuRING THIS ENTIRE PRoCESS.

To CALIBRATE:

1. Plug the machine into an outlet and turn on the power (in Owner's Manual see Page 24: Turning on the Power).

2. Stand on the side foot support platforms or rubber floor mat, Do NoT STAND oN THE BELTS.

3. Insert the Safety Key into the magnetic holder on the console display.

4. The console display will show "CAL ... PRSS ... STRT", press the START key. This will start the calibration procedure.

If the power has been turned on before and the display does not show "CAL ... PRSS ... STRT", press the

POWER key on the console to turn the console power off (the dislay should be blank). Then press the ENTER

and DOWN SPEED keys simultaneously until "CAL ... PRSS ... STRT" is displayed.

NOTE: During the calibration procedure, the belts will start and stop and the displays will show various

numbers that relate to calibration - DO NOT INTERRUPT CALIBRATION.

5. At the end of the Calibration Procedure the display will show "CAL ... PASS". Press the POWER key on the

console to exit the Calibration Mode.

NOTE: If your console display does not finish the calibration procedure by displaying "CAL ... PASS" proceed to

the Electrical and Mechanical Troubleshooting Guide.

When the Bowflex

TreadClimber® fitness machine has completed calibration, you may begin your workout.

FAILURE TO CALIBRATE YOUR MACHINE PRIOR TO USE COULD RESULT

IN MACHINE FAILURE AND COULD CAUSE INjURY.

FAILURE TO RE-CALIBRATE YOUR MACHINE AFTER REPLACING ANY

ELECTRONICS PRIOR TO USE COULD RESULT IN MACHINE FAILURE

AND COULD CAUSE INjURY.

DURING THE ENTIRE CALIBRATION PROCEDURE, STAND ON THE SIDE

FOOT SUPPORT PLATFORMS OR RUBBER MAT ONLY, Do NoT STAND oN

THE WALKING BELTS!