How To Remove The Oven Door; Replacing The Oven Lamp; Installation; Before The Installation - Technika T45COG Instructions For Use And Installation

 Clean the glass door using non-abrasive products or sponges and dry it with a soft cloth.

9.1 How to remove the oven door

For a more thorough clean, you can remove the oven door.
Proceed as follows:
1） Open the door fully.
2） Lift up and turn the small levers situated
On the two hinges.
3） Grip the door on the two external sides; shut it slowly but not completely.
4） Pull the door towards you ,pulling it out of its seat ;
Reassemble the door by following the above procedures backwards.

9.2 Replacing the oven Lamp

1) Disconnect the oven from the power supply by means of the Omni polar switch used to
connect the appliance to the electrical mains ;or unplug the appliance if the plug is
accessible ;
2）Remove the glass cover of the lamp-holder ;
3）Remove the lamp and replace with a lamp resistant to high temperatures (300℃)
With the following characteristic.
 Voltage：220-240V
 Wattage：25W
 Type：E14
5） Replace the glass cover and reconnect the oven to the mains
Power supply

10. INSTALLATION

10.1 Before the Installation

 Please check the products shell and make sure that there is no traces caused by striking or
heavy load.
 The oven door is level, and you can close door flexibly.
 Parameter on the nameplate is in compliance with the relevant regulations
When the oven working in a abnormal way, it must be stopped and unplug the power supply
until it has been repaired by a competent person from local agency or factory authorized service.
It is hazardous for anyone other than a competent person to carry out any service or repair
operation
10.2 Installation
Only a qualified person in compliance with the instructions provided must install the
appliance .manufacturer declines all responsibility for improper installation, which may harm
persons and animals and damage property.
Important: - The power supply to the appliance must be cut off before any adjustments or
maintenance work is done on it;
- Air duct is supposed to use in Ventilation.

10.3 Installation of Built-in Ovens

If we put the oven into cabinet, the material cabinet should be insulated, and the clearance
between the edge of the cabinet and the oven should be over 100mm for ventilation.