Wheels; Muffler/Spark Arrester; Light Bulb Replacement; Spark Arrester/Muffler - Arctic Cat PROWLER XT Operator's Manual

! WARNING
Use only Arctic Cat approved tires
when replacing tires. Failure to do so
could result in unstable operation.
Tubeless Tire Repair
Should a leak or flat tire occur due to a punc-
ture, the tire may be repaired using a plug-
type repair. If the damage is from a cut or if
the puncture cannot be repaired using a plug,
the tire must be replaced. When operating
the vehicle in areas where transportation or
service facilities are not readily available, it
is strongly recommended to carry a plug-
type repair kit and a tire pump along.

Wheels

1. Park the vehicle on level ground and
engage the parking brake and the dif-
ferential lock.
2. Loosen the lug nuts on the wheel to
be removed.
3. Elevate the vehicle.
4. Remove the lug nuts.
5. Remove the wheel.
6. Install the wheel and install the lug
nuts.
7. Tighten the nuts in a crisscross pat-
tern in 20 ft-lb increments to 40 ft-lb
(steel wheels) or 80 ft-lb (aluminum
wheels).
8. Remove the jack.

Muffler/Spark Arrester

The muffler has a spark arrester which must
be periodically cleaned. At the intervals
shown in the Maintenance Schedule, clean the
spark arrester using the following procedure.
! WARNING
Wait until the muffler cools to avoid
burns.
1. Remove the cap screws securing the
spark arrester assembly to the muf-
fler.
2. Using a suitable brush, clean the car-
bon deposits from the screen taking
care not to damage the screen.

NOTE: If the screen or gasket is
damaged in any way, it must be
replaced.
3. Install the spark arrester assembly
and secure with the cap screws.
Tighten to 60 in.-lb.

Light Bulb Replacement

The wattage rating of each bulb is shown
in the chart. When replacing a burned
bulb, always use the same wattage rating.
Headlight
Taillight/Brakelight
CAUTION
Use only specified bulbs indicated in
the chart as replacement bulbs.

NOTE: The bulb portion of the
headlight is fragile. HANDLE WITH
CARE. When replacing the head-
light bulb, do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing. Skin oil
residue on the bulb will shorten the
life of the bulb.
XT/XTZ
PR498
XTX
PR856
12V/27W (4)
12V/8W/27W
49