Solid-State Drive (M.2) - HP ENVY Maintenance And Service Manual

Solid-state drive (M.2)

Description
256 GB solid-state drive, M.2, TLC
128 GB, 2280 M.2
128 GB solid-state drive, M.2, TLC (Best Buy SKUs)
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery.
Remove the solid-state drive:
1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board.
2. Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
42 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page 35).
Spare part number
812708-001
829985-001
820547-001