Connecting The Multimedia Control Panel (Sistore Mx / Remoteview) - Siemens SISTORE MX Installation Manual

8.4.3

Connecting the Multimedia Control Panel (SISTORE MX / RemoteView)

Siemens Building Technologies
Fire Safety & Security Products
6. Mark the checkbox C CTV keyboard. Further information on this can be found
T
in the SISTORE MX Configuration Manual.
7. Click Apply.
The interface for the control panel is enabled.
Connections
Signal
GND
RXD
TXD
CKA4820 interface configuration
Protocol: SIMATRIX RS232 or SIEMENS IVM
Baud rate: 9600
Parity: None
The Multimedia Control Panel (ShuttlePRO2, see Section
Siemens Building Technologies Fire & Security Products GmbH & Co. oHG. It can be ordered from
Contour Design Ltd. (www.contourdesign.com) (product name: ShuttlePRO2).
The Multimedia Control Panel has been integrated and tested with SISTORE MX. Siemens Building
Technologies Fire & Security Products GmbH & Co. oHG can however not guarantee fault-free
operation of the Multimedia Control Panels and does not provide any support. In case of problems
with the product, please contact the manufacturer (www.contourdesign.com).
Fig. 17 SISTORE – Multimedia Control Panel system overview
To install the Multimedia Control Panel on a SISTORE without DVD drive, you must carry out the
following steps:
1. Copy the files on the accompanying CD onto an external USB storage medium.
2. Plug the storage medium into a USB port on the SISTORE.
3. Launch the file Autorun.exe from the USB storage medium.
4. Proceed with step 4 in subsection Installing the Multimedia Control Panel.
Client PC
SISTORE RemoteView
5
3
2
4 D etails for ordering
1 1 6 H 1 1 7 H
Installation
CKA4820
9-pin Sub-D plug
5
2
3
) is not a product of
1 1 8 H
33
02.2009