Table of Contents
Advertisement
4. Glue the throttle servo mount riser to the fuse
side as shown below.
5. Spread an even amount of 5 Minute epoxy on
the servo mount where it will be glued to the
fuse.
6. Install the servo mount as shown aligning servo
to throttle pushrod, allow the glue to fully cure
before moving on to the next step.
7. Using the same method as described for the
choke linkage solder the threaded coupler onto
the throttle linkage and install as shown below.
Note: Ensure throttle linkage will not interfere with
fuel tank.
44
Hide quick links:
Advertisement
Table of Contents
