Epson EPL-9000 Service Manual page 116

Service Manual
There are four screws securing the
these screws while removing the engine driver
from the unit, it is possible for reflected light from the
damage. Therefore, do not remove the four screws, as shown in the following figure.
A CAUTION label is pasted under the engine driver
damage. Be sure to follow the procedure on the label when you open and shut the
cover. However, you do not need to open and shut this cover when replacing a defective
unit.
Remove the rear cover. (Refer to Section 3.2.1.1.)
1.
2. Remove the top cover. (Refer to Section
3. Remove cover. (Refer
4. Remove theright cover. (Refer to Section
5. Remove the ELEC cover. (Refer to Section
6. Remove the fusing unit. (Refer to Section
7. Disconnect all
8. Remove 2 screws
engine driver
9. Remove the high
10. Remove thelink assembly. (Refer to Section
11. Remove theearth plate. (Refer to Section 3.2.2.6.)
12. Remove the front cover. (Refer to Section 3.2.4.5.)
13. Remove the drive unit. (Refer to Section 3.2.6.1.)
14. Remove the CRUSENSORPWB board. (Refer to Section 3.2.6.2.)
15. Remove the REGI roller. (Refer to Section 3.2.4.2.)
16. Remove thelower chute assembly. (Refer to Section 3.2.4.3.)
17. Remove theerase lamp. (Refer to Section 3.2.6.3.)
18. Remove 6 CBB screws
Rev.
unit cover.
Screws
Figure 3-49. Screw Positions
3.2.1.3.)
from the engine driver
x 6) securing the
board.
nit. (Refer to Section 3.2.2.4.)
x 10) securing the
and
Disassembly and Assembly
you unintentionally remove three of
board and high voltage unit
to leak and cause
board to help you avoid
board.
box, and remove the
unit, and remove it.
from the unit.
unit
box and the
3-31