Rack Mounting - Shure PSM 300 User Manual

Signal Routing to External Devices
(Combination Systems)
The LOOP outputs pass audio to an external device, such as other person-
al monitoring systems, recording devices, or stage monitors. The signal
at the LOOP outputs is identical to the signal coming from the mixer, and
is not affected by the transmitter volume or input sensitivity (line/aux) set-
tings. This makes the LOOP outputs particularly useful when using a mixer
that has one or two monitor/auxiliary sends.
Using the PSM300 simultaneously with Loudspeakers:
A combination monitoring system can be used, where some of the per-
formers are using the PSM300 wireless system and others are listening
through loudspeakers on stage.
Note: If using passive stage monitors, the P3T outputs must be connected
to an amplifier. Active (amplified) speakers can be connected directly to
the P3T outputs.
Using the PSM300 Combined with Other Wireless
Monitoring Systems
In a scenario where two performers have their own wireless monitoring
systems (one Shure PSM300 system and one third-party system, for ex-
ample), the PSM300 can pass the signal from the mixer on to the second
monitoring system.
System Setup and Configuration

Rack Mounting

The P3T Transmitter can be mounted in a standard 19-inch rack. Up to
two units can be mounted in a single rack space. If using multiple P3T
transmitters, the Shure PA411 Antenna Combiner system can be used to
consolidate and distribute all RF and power for up to four transmitters.
8
Transmitter LOOP Outputs
POWER MONO/STEREO-MX LINE/AUX L - LOOP OUT - R
Mixer Auxiliary/Monitor Outputs
Single unit
Dual-mounting two units
Note: Always use both straddle bars when mounting two units.
Stage Monitor Loudspeaker
LEFT/CH.1 IN RIGHT/CH.2 IN ANTENNA
Amplifier