D-Link DGS-3324SRi User Manual page 102

D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch
To setup a new IP interface, click the Add button. To edit an existing IP Interface entry, click on an entry under
the Interface Name heading. Both actions will result in the same screen to configure, as shown below.
Choose a name for the interface to be added and enter it in the Interface Name field (if you are editing an IP
Interface, the Interface Name will already be in the top field as seen in the window above). Enter the interface's
IP address and subnet mask in the corresponding fields. Pull the State pull-down menu to Enabled and click
Apply to enter to make the IP interface effective. Use the Save Changes dialog box from the Basic Setup folder
to enter the changes into NV-RAM.
The following fields can be set:
Parameter
Interface Name
IP Address
Subnet Mask
VLAN Name
State <Disabled>
Link Status <Link
UP>
Figure 4- 57. IP Interface Table window
Figure 4- 58. IP Interface Configuration window
Description
This field displays the name for the IP interface. The default IP interface is
named "System".
This field allows the entry of an IP address to be assigned to this IP
interface.
This field allows the entry of a subnet mask to be applied to this IP interface.
This field allows the entry of the VLAN Name for the VLAN the IP interface
belongs to.
This field may be altered between Enabled and Disabled using the pull
down menu. This entry determines whether the interface will be active or
not.
This read only field states the current status of the IP Interface on the
Switch. Link Up denotes that the IP interface is up and running on the
Switch. Link Down will denote that the IP interface is not currently set and/or
enabled on the Switch.
87