AT&T TL92328 User Manual page 84

Appendix D
Troubleshooting
The handset
screen shows
PRESS HNDST
LOC 4 SEC ON
BASE and the
handset is out
of the telephone
base or charger.
SEARCHING
FOR BASE
displays on my
cordless handset.
The batteries
will not hold a
charge.
I get noise,
static, or weak
signals even
when I'm near
the telephone
base.
• Unplug the battery from the handset and plug it
back in (page 9). The screen should now show NOT
REGISTERED and you can follow the registration
instructions on page 73.
• Ensure that the telephone base is powered up.
• Place the cordless handset in the telephone base for
one minute to allow the cordless handset and base to
resynchronize.
• Move the cordless handset closer to the telephone base.
You might have moved out of range.
• Reset the telephone base. Unplug the unit's electrical
power. Wait for 15 seconds then plug it back in.
Allow up to one minute for the cordless handset and
telephone base to reset.
• Other electronic products can cause interference with
your cordless phone. Try installing your phone as far
away from these types of electronic devices as possible:
television sets, VCRs, or other cordless telephones.
• If the cordless handset is in the telephone base or
charger and the charge light does not come on,
refer to The charge light is off on page 82 in this
Troubleshooting guide.
• Charge the battery in the cordless handset for at least
16 hours. For optimum daily performance, return the
cordless handset to the telephone base or charger when
not in use.
• You may need to purchase a new battery. Please refer
to Battery installation & charging, pages 8-9, in this
user's manual.
• If you subscribe to high-speed Internet service (digital
subscriber line - DSL) through your telephone lines, you
must install a DSL filter between the telephone base and
the telephone wall jack (see page 6). The filter prevents
noise and caller ID problems caused by DSL interference.
Please contact your DSL service provider for more
information about DSL filters.
79