Remote Dial Pad Registration And De-Registration; Register The Remote Dial Pad To The Headset Base (With A Single Headset) - AT&T TL7601 User Manual

Getting started

Remote dial pad registration and de-registration

The TL7601 remote dial pad allows you to place phone calls with
an AT&T DECT 6.0 cordless headset system. You must register it to
the TL7610/TL7611/TL7650/TL7651 headset base before use. The
remote dial pad should be charged for a minimum of five minutes
before attempting registration to the headset base. You cannot
register the dial pad to the headset base before a headset is
registered to the headset base.
The remote dial pad does not work with an AT&T DECT 6.0 cordless
headset system that is connected to a telephone that is part of a
digital business system unless there is an analog adapter on the
line. Please contact your IT department, telephone administrator,
or your telephone service provider to determine if this remote dial
pad is compatible with your telephone system.
NOT REGISTERED
PRESS PAIR
4 SEC ON BASE
Register the remote dial pad to the
headset base (with a single headset)
1. The new remote dial pad should be
charged for at least five minutes before
registering to the headset base. When
the remote dial pad is removed from the
charger, it shows NOT REGISTERED on
the screen.
2. Place the unregistered remote dial
pad into the charger. If
4 SEC ON BASE
the remote dial pad screen after a few
seconds, remove the remote dial pad
and place it in the charger again.
On
3. On the headset base, press and hold
the PAIR button for about four seconds
does not appear on
6
PRESS PAIR