Table of Contents
Advertisement
S
S
UPER
ERVER 8046B-6RF/8046B-TRF User's Manual
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the LAN1/LAN2 Eth-
ernets port on the serverboard. See the
table on the right for jumper settings.
The default setting is enabled.
VGA Enable/Disable
JPG1 allows you to enable or disable
the VGA port. The default position is on
pins 1 and 2 to enable VGA. See the
table on the right for jumper settings.
TPM Support Enable
JPT1 allows the user to enable TPM
(Trusted Platform Modules) support
to enhance data integrity and system
security. See the table on the right for
jumper settings. The default setting is
enabled.
SAS2 Enable (X8QB6-F only)
Close pins 1-2 to enable SAS2 (Serial
Attached SCSI) support for the X8QB6-
F serverboard. See the table on the
right for jumper settings. The default
setting is enabled.
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Jumping pins 1-2
will cause WD to reset the system if an
application hangs. Jumping pins 2-3
will generate a non-maskable interrupt
signal for the application that hangs.
See the table on the right for jumper
settings. Watch Dog must also be en-
abled in BIOS.
LAN1/2 Enable/Disable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
TPM Support Enable/Disbale
Jumper Settings
Jumper Setting
1-2
2-3
SAS2 Enable/Disable
Jumper Settings
Jumper Setting
1-2
2-3
Watch Dog
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Open
5-20
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Defi nition
Enabled (Default)
Disabled
Defi nition
Reset
NMI
Disabled
Advertisement
Table of Contents
