AT&T SPIRIT SPIRIT Attendant Owner's Manual page 9

studs or cross members), partially screw the
two screws into the wall at the marks,
remove them, hang the tabs on the screws,
and then tighten the screws.
For plaster, plasterboard, cinder block, or
brick surfaces, drill a 3/16" hole at each
mark and insert an anchor into each of the
holes. Gently tap each anchor with a ham-
mer until it is flush with the surface. Screw
the screws partially into the anchors, remove
them, hang the tabs on the screws, and then
tighten the screws.
Step 2 — Connect the SPIRIT Attendant
ConnecT/R to the controller and the SPIRIT
5
Attendant to the SPIRIT Attendant
ConnecT/R.
Please check the cabling requirements in Appen-
dix A before proceeding. Consult with the
person who customized your SPIRIT System
before attaching the SPIRIT Attendant
ConnecT/R to the controller.
NOTE: The "4-wire cord" mentioned in the
steps below comes with the SPIRIT Atten-
dant ConnecT/R. Any cord you may have
that is connecting a SPIRIT Telehone to
the controller is also 4-wire cord .