Step 1- Mount The Spirit - AT&T SPIRIT SPIRIT Attendant Owner's Manual

Step 1 — Mount the SPIRIT Attendant
ConnecT/R (optional).
The SPIRIT Attendant ConnecT/R is designed
to be placed on your desk or mounted on any
vertical surface. Do not place it on the floor.
Hardware has been included to mount the
SPIRIT Attendant ConnecT/R on the wall: two
plastic wall-mount tabs, two anchors, and two
#6 screws.
Select an appropriate location. The SPIRIT
1.
Attendant ConnecT/R can be no more than
six feet from its power supply (an AC outlet
that isn't controlled by a wall switch) and no
more than six feet from the devices attached
to it. The bottom of the SPIRIT Attendant
ConnecT/R should be at least two feet from
the floor.
Position the SPIRIT Attendant ConnecT/R
2.
so the side with the jacks and settings is
down or to the side, but not up.
Remove the backing from the plastic tabs.
3.
4. Gently position a tab by aligning the end of
the adhesive with the outside edge of the
SPIRIT Attendant ConnecT/R and the side
of the tab against the inside of one of the
feet. Repeat for the second tab.
Press the tabs firmly into position.
5.
6. With the tabs at the top, hold the SPIRIT
Attendant ConnecT/R against the wall
where you plan to mount it and use a pencil
to mark the location of the holes in the tabs.
The bottom of the SPIRIT Attendant
ConnecT/R should be at least two feet from
the floor.
If you have plywood walls or walls with a
7.
sturdy supporting structure (either wood