Table of Contents
Advertisement
5
Utilisation with the control panel B-Control
5.1
Use of the control panel
Fig.13
Press the
key
Fig.14
Accessing the Information menu
Fig.15
Accessing the Chimney Sweep
menu
5.2
Start-up
7642066 - v01 - 29092015
5.1.1 Accessing the menus
1. The
down the information in the Information menu.
MW-3000237-1
2. To access the Information menu, press the
Note
Five minutes after the
play goes back to the main display, once the venting cycle has
been completed.
MW-3000238-1
3. To access the Chimney Sweep menu, press the
onds.
Note
Thirty minutes after the
play goes back to the main display.
For more information, see
Information menu, page 26
MW-3000239-1
1. Check that the heating system and the boiler are adequately primed
with water.
2. Check that the storage tank is duly filled with fuel.
3. Check the water pressure in the heating system. The recommended
water pressure is 0.15 MPa (1.5 bar).
4. Open the oil inlet valve.
5. Switch on the boiler.
6. A venting cycle is run automatically.
7. The display shows the operating status of the boiler, the heating flow
temperature and any error codes.
5 Utilisation with the control panel B-Control
key is used to access the various menus and to scroll up and
key is pressed for the last time, the dis
key is pressed for the last time, the dis
key once.
key for two sec
EFU
17
Advertisement
Table of Contents
