AT&T SL82218 User Manual page 16

Getting started
Mounting bracket procedure
Desktop to wall mount installation
8. Route the other end of the telephone line cord through the bottom of the
bracket until it loops through the large rectangular opening in the middle
of the bracket as shown in Figure 7 below.
9. Plug the power adapter into an electrical outlet not controlled by a wall
switch.
10. Plug the telephone line cord into
the wall plate telephone jack.
Align the holes on the telephone
base with the standard wall plate.
Figure 8. Wall mount alignment
11. Slide the telephone base down
until it locks in place. Make
sure the telephone is securely
positioned as shown in Figure 9,
and raise the antenna.
Figure 9. Wall mount position
13
Figure 7. Cord routing