Getting started
Telephone base and charger installation
Telephone base installation
1.
Plug the small end of
the larger power adapter
into the power jack at
the bottom of the tel-
ephone base.
5.
Plug the large end of
the larger power adapt-
er into an power outlet
not controlled by a wall
switch.
Power
adapter
Charger installation
1. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
IMPORTANT INFORMATION
1. Use only the power adapter supplied with this product. To order a replacement power adapter,
visit our website at
1 (866) 288-4268.
Canada dial
2. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
3. If you receive high speed internet through your telephone line (commonly referred to as DSL),
and you are experiencing interference during telephone conversations and/or your caller ID
features are not functioning properly, install a DSL filter to the telephone line between the
telephone base and the telephone wall jack. Contact your DSL provider for a DSL filter.
www.telephones.att.com
Telephone
line cord
DSL filter
(not included)
1 (800) 222-3111.
or call
5
2.
Plug one end of the tele-
phone line cord into the tel-
ephone jack at the bottom
of the telephone base.
3.
Route cords
through slots.
4.
Plug the other end of
the telephone line cord
into a telephone jack.
2. Plug the large end of
the smaller power adapter
into an electrical outlet.
In