Table of Contents
Advertisement
Installation
1. Before installing the optional synchronous pipeline burst
cache module, make sure that:
- the cache chips have been removed from the
SRAM sockets U23 (Tag RAM) and U28-U35;
- Jumpers JP12-JP15 have been set properly (page
26).
2. Locate the 160-pin cache module slot on the system
board. Position the cache module above the slot. Make
sure pin 1 of the cache module is aligned with pin 1 of
the slot. Carefully slide the module into the slot. Press
firmly on the top of it to seat it properly.
Note:
With the optional synchronous pipeline burst cache
module installed in the cache module slot, the length of
the add-in card in PCI Slot 2 is limited to 124,65 mm.
G586OPC/E
27
Advertisement
Table of Contents
