installation
|
46
OPTIONAL WALL THERMOSTAT INSTALLATION
This installation must be completed during initial install with the front access
panel removed.
A wall thermostat may be installed if desired.
Recommended: The wall thermostat should be mounted beside the
Remote/Unit Receiver which comes standard with the appliance.
1. Run wires from thermostat into the unit.
2. Remove the green wire marked (TH) at the white connector-shown
below. The noted wires will be located near the gas valve.
Green Wires
Disconnect greenTH wire
3. Connect one thermostat lead to female connector, using male spade
connector - see picture below.
46 |
Regency Horizon ® HZ40E-10 Gas Fireplace
White Connector
4. Connect the other thermostat lead to male connector disconnected
from Step1using a female spade connector - see picture below.
When complete turn remote receiver to the ON position.
Unit will now operate using the wall thermostat.
NOTE: When the remote receiver is set to ON position, the remote
control transmitter and all of its features are now disabled.
CAUTION
Do not wire
Thermostat wires
to 120V wire.