Safety Screen Removal / Installation - Regency Fireplace Products Horizon HZ40E-NG10 Owners & Installation Manual

installation
|
52
SAFETY SCREEN/INNER DOOR FRAME REMOVAL/ INSTALLATION
SAFETY SCREEN / INNER DOOR FRAME REMOVAL/INSTALLATION
THE INNER DOOR FRAME (3) MUST BE PURCHASED SEPARATELY IN EITHER STAINLESS STEEL OR BLACK
1. The inner door trim (1) and safety screen (2) come attached to the fireplace.
Remove the inner door trim and safety screen by pulling the bottom of the
trim towards you as one, then lift up.
1
2. Remove screws from inner side of the inner door trim and discard screws
and the brackets. (Brackets not shown). Remove the screen mesh from
inner door trim.
3. Install screen into inner door frame - secure safety screen by bending in 6
tabs in locations shown below.
52 |
Regency Horizon ® HZ40E-10 Gas Fireplace
919-452
2
3
Screw Locations
Tabs
4. Hook the inner door frame (3) and safety screen assembly (2) over
the inner door trim.
5. Bend the center tab up and secure with a screw to attach the inner
door frame/safety screen assembly to the inner door trim
6. Attach completed assembly to the glass door on unit.
7. Secure the assembly with 1 screw on each side.
8. HZ42STE only - repeat Steps 1-7 to install screen and door frame on
other side.
1 01.05.15