Lldp-Med Network Policy - ZyXEL Communications MGS3520 Series User Manual

The following table describes the labels in this screen.
Table 148 Advanced Application > LLDP > LLDP-MED Configuration
LABEL
Port
*
Notification
Topology
Change
MED TLV Setting
Location
Network Policy
Apply
Cancel

36.8 LLDP-MED Network Policy

Click Advanced Application > LLDP > LLDP-MED Network Policy (Click Here) to display the
screen as shown next.
Figure 192 Advanced Application > LLDP > LLDP-MED Network Policy
Chapter 36 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
This displays the Switch's port number. Select * to configure all ports simultaneously.
Use this row to make the setting the same for all ports. Use this row first and then make
adjustments to each port if necessary.
Changes in this row are copied to all the ports as soon as you make them.
Select to enable LLDP-MED topology change traps on this port.
Select to enable transmitting LLDP-MED location TLV.
Select to enable transmitting LLDP-MED Network Policy TLV.
Click Apply to save the changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MGS3520 Series User's Guide
309