Configuring Static Multicast Forwarding - ZyXEL Communications MGS3520 Series User Manual

Figure 62 Static Multicast Forwarding to Multiple Ports

11.2 Configuring Static Multicast Forwarding

Use this screen to configure rules to forward specific multicast frames, such as streaming or control
frames, to specific port(s).
Click Advanced Application > Static Multicast Forwarding to display the configuration screen
as shown.
Figure 63 Advanced Application > Static Multicast Forwarding
The following table describes the labels in this screen.
Table 37 Advanced Application > Static Multicast Forwarding
LABEL
Active
Name
MAC Address
Chapter 11 Static Multicast Forward Setup
DESCRIPTION
Select this check box to activate your rule. You may temporarily deactivate a rule without
deleting it by clearing this check box.
Type a descriptive name (up to 32 printable ASCII characters) for this static multicast MAC
address forwarding rule. This is for identification only.
Enter a multicast MAC address which identifies the multicast group. The last binary bit of the
first octet pair in a multicast MAC address must be 1. For example, the first octet pair
00000001 is 01 and 00000011 is 03 in hexadecimal, so 01:00:5e:00:00:0A and
03:00:5e:00:00:27 are valid multicast MAC addresses.
MGS3520 Series User's Guide
123