Subaru Forester 2016 Owner's Manual page 417

Hide thumbs Also See for Forester 2016:
Table of Contents

Advertisement

follows.
Before starting the engine
Before using the remote engine start
system to start the engine, confirm the
following conditions.
. The select lever is in the P position.
. All doors including the rear gate are
closed.
. The engine hood is closed.
. The push-button ignition switch is in the
OFF position.
Starting the engine
To start the engine with remote engine
start system, briefly press the lock button
twice within 2 seconds, then press and
hold the lock button for 3 seconds.
1. Press the lock button briefly. The
hazard warning flashers then flash once.
2. Within 2 seconds, press the lock
button briefly again. The hazard warning
flashers then flash once again.
3. After step 2, immediately press and
hold the lock button. The hazard warning
flashers then flash once.
4. Approximately 3 seconds after step 3,
release the lock button. The engine will
then start successfully.
Starting and operating/Remote engine start system (dealer option)
Stopping the engine
Press and hold the lock button to stop the
engine with remote engine start system.
Automatic engine shutdown
The remote engine start system will
automatically shut down or will not start
the engine under the following conditions.
. The total run-time has exceeded 20
minutes.
. Any door or the rear gate is opened.
. The select lever is moved to any
position other than P .
. The engine hood is opened.
. The push-button ignition switch is
pressed.
. The brake pedal is depressed.
. The engine speed is 3,000 rpm or
more.
The time setting until the engine auto-
matically stops can be changed. To
change it, please contact your SUBARU
dealer. Note that some settings may
violate state, provincial, or local laws and
regulations. Check the laws in your area to
determine which setting is permitted.
Models without keyless ac-
cess with push-button start
system
Remote engine starter transceiver (fob)
1)
Fob button
Starting the engine
NOTE
All vehicle doors (including rear gate)
and the engine hood must be closed
prior to activating the remote engine
start system. Any open entry point will
prevent starting or cause the engine to
stop.
The remote engine start system is acti-
vated by pressing the fob button on your
remote engine starter transceiver (fob)
twice within 3 seconds. If the fob is within
CONTINUED
7-15

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents