Subaru Forester 2016 Owner's Manual page 241

Hide thumbs Also See for Forester 2016:
Table of Contents

Advertisement

ference, and (2) this device must
accept any interference received, in-
cluding interference that may cause
undesired operation.
. Canada-spec. models
NOTE
This device complies with Industry
Canada licence-exempt RSS standard
(s). Operation is subject to the follow-
ing two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference,
including interference that may cause
undesired operation of the device.
NOTE
Le présent appareil est conforme aux
CNR d Industrie Canada applicables
aux appareils radio exempts de licence.
L exploitation est autorisée aux deux
conditions suivantes: (1) l appareil ne
doit pas produire de brouillage, et (2)
l utilisateur de l appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d en compromettre le fonctionnement.
HomeLink
and the HomeLink
®
®
registered trademarks of Johnson Con-
trols, Inc.
. W h e n p r o g r a m m i n g
HomeLink
®
tem, you may be operating a
garage door opener or other
device. Make sure that people
and objects are out of the way
of the garage door or other
device to prevent potential harm
or damage.
. Do not use the HomeLink
less Control System with a gar-
age door opener that lacks the
safety stop and reverse feature
as required by applicable safety
standards. A garage door opener
which cannot detect an object,
signaling the door to stop and
reverse, does not meet these
safety standards. Using a garage
door opener without these fea-
tures increases risk of serious
injury or death. For more infor-
mation, consult the HomeLink
website at www.homelink.com or
call 1-800-355-3515.
house are
Instruments and controls/Mirrors
WARNING
t h e
When programming the HomeLink
Wireless Control Sys-
Wireless Control System to operate
a garage door opener or an entrance
gate, unplug the device s motor
from the outlet during programming
to prevent motor burnout.
NOTE
. After programming your HomeLink
Wire-
®
Wireless Control System for the de-
sired devices, retain the hand-held
transmitters for further programming
or device testing in the event of a
problem.
. It is recommended that you insert a
new battery in the hand-held transmit-
ter of a device to ensure correct
programming.
NOTE
®
When programming the HomeLink
Wireless Control System for a garage
door opener, it is suggested that you
park the vehicle outside the garage.
1. Unplug the motor of the garage door
opener from the outlet.
3-99
CAUTION
Garage door opener program-
ming in the U.S.A.
CONTINUED
®
®
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents