Setting Surface Controls; Single Radiant Elements - Kenmore 970-6885 Series Use & Care Manual

Setting Surface Controls

Single radiant elements

The cooktop provides three single
radiant element locations as
illustrated. Use the following
instructions when operating these
elements.
The suggested power level settings shown in Fig. 1 are
based on cooking with medium sized aluminum pans with
lids. Be sure to make any further setting adjustments for
best surface cooking results.
Suggested radiant element power level settings table
(for triple and single elements)
Setting Type of cooking
High (8.0 - Hi) Start most foods, bring water to a
boil, pan broiling
Medium high (5.0-8.0) Continue a rapid boil, fry, deep
fat fry
Medium (3.0 - 5.0) Maintain a slow boil, thicken
sauces and gravies or steam
vegetables
Medium low (2.0 - 3.0) Keep foods cooking, poach, stew
(2.8 or lower is a simmer setting)
Low (Lo - 2.0) Keep warm, melt, simmer (2.8 or
lower is a simmer setting)
Hot Surface (HE) indicator message
When using any of the radiant element positions, the
cooktop will become very hot. After turning any of the
elements off the cooktop may remain HOT for some time.
The corresponding HE indicator message (Fig. 4) will turn
on whenever any element position becomes HOT and turn
off once the cooktop has cooled sufficiently.
Radiant surface elements may appear to
have cooled after they have been turned off. The glass
surface may still be hot and burns may occur if the glass
surface is touched before it has cooled sufficiently.
Do not place aluminum foil or plastic
items such as salt and pepper shakers, spoon holders or
plastic wrappings on top of the range when it is in use.
These items could melt or ignite. Potholders, towels or
wooden spoons could catch fire if placed too close to the
surface elements.
Fig. 1
To operate single radiant elements:
1. Place correctly sized cookware on radiant element.
2. To activate press and hold the
desired element until acceptance tone sounds.
3. To set power level press Hi, Med (5.0) or Lo keypad and
if needed toggle the Hi or Lo keypads to adjust to the
desired power level setting. Each touch of the Hi or Lo
key pad will decrease or increase the power level by
1/2 from 9.5 through 3.0. Simmer power levels between
3.0 and 1.2 will decrease or increase by .2 increments.
Hi (Fig. 2) is the highest power level. Lo (Fig. 3) is the
lowest power level available.
4. Once cooking is finished, press
element OFF.
Fig. 2
Important notes:
• Start most cooking operations on a higher setting and
then turn to a lower setting to finish cooking.
• For efficient cooking, turn the surface element OFF
several minutes before cooking is complete. This will
allow residual heat to complete the cooking process.
• A glowing red surface heating area extending beyond
the bottom edge of the cookware indicates the cookware
is too small too small too small for the surface heating area. too small
too small
• Radiant elements have a limiter that allows the radiant
heating element to cycle ON and OFF, even at the HI
setting. This helps prevent damage to the ceramic
cooktop. Cycling at the HI setting is normal and will
occur more often if the cookware is too small for the
radiant element or if the cookware bottom is not flat.
11
keypad for the
keypad to turn the
Fig. 3 Fig. 4