Fisher & Paykel ActiveSmart E372B Installation Instructions And User Manual page 17

Important!
All connections must be checked for leaks.
■ ■
Ensure 6 mm (1/4") tubing is routed away from sharp objects,
■ ■
sharp corners (beware of kinking tube as this will stop water
flow), clear of the refrigerator unit compartment and not in a
location where it can be squashed.
Ensure all push-fit connections are firmly pushed into place.
■ ■
The tube should be pushed in 16 mm (5/8") before reaching
the stop.
If tubing is removed at any point, re-cut the end and re-insert.
■ ■
Tubing must be fully inserted to avoid leaks.
To remove tube from connection points, turn off the isolating
■ ■
tap, push in the collet and gently pull tubing at the same time
(refer to Diagram 6).
Open rear compartment installation
Mark a line of 16 mm (5/8") on the end of the tube. Firmly push the marked water tube into the
1
water (solenoid) valve located on the right hand side of the rear compartment until the marked
line is not visible (refer to Diagram 7). Beware of hot pipes.
Pull gently on tubing to ensure it is locked (refer to Diagram 8).
2
The completed installation should look like Diagram 9. Turn isolating tap on and check that all
3
connections are dry and free of drips.
Coil water line tubing behind the refrigerator and push into position being careful not to kink or
4
squash the water line running into the water (solenoid) valve.
Diagram 7
Installation instructions
Diagram 8
15
Diagram 6
Diagram 9
Completed installation