Fisher & Paykel ActiveSmart E372B Installation Instructions And User Manual page 19

Before you start using your Ice & Water refrigerator
To flush the water filtration system
Ensure your refrigerator is switched on, and the isolation tap has been connected and turned on.
■ ■
Run your water dispenser pad until water dispenses, this will displace trapped air in the water
■ ■
tank and filter system. This will take at least 2 minutes. Once water has dispensed, rest the
dispenser pad for 2 minutes.
Dispense and discard 4 litres (4 qt) of water, then rest the dispenser pad for a further 2 minutes.
■ ■
Dispense and discard a further 4 litres (4 qt) of water. Failure to do this will result in excessive
■ ■
dripping from your dispenser.
Please note, once installation is complete a few drips may appear out of the dispenser over the
■ ■
next few days to clear the remaining trapped air.
Turn the ice maker on by pressing the
■ ■
illuminated when the ice maker is on.
Press and hold the
■ ■
refrigerator compartment door to force an ice maker cycle. The ice tray will flip twice. Repeat
to force another ice maker cycle. The ice tray will flip twice and spill water into the ice bin.
Empty the water, dry and replace the bin. Note that the ice tray will not flip until the refrigerator
compartment door is closed.
Please discard the first 3 harvests of ice (8 cubes per harvest).
■ ■
Ensure your refrigerator has cooled for at least 2 hours before use.
■ ■
You are now ready to enjoy ice and water from your refrigerator.
button. The light above the
, and buttons together for 4 seconds and then close the
Water dispenser
Installation instructions
17
button will be