Instructions For Safe Use - Oce DFS10 Operator's Manual

Instructions for safe use

The DFS10 and its supplies have been designed and tested to meet strict safety requirements.
These requirements include examination and approval by a safety agency and compliance
with established environmental standards.
To make sure that the hardware operates safely, please adhere to the following safety
recommendations:
General safety
• The DFS10 is heavy. Ensure that the floor is level and strong enough to support the
weight of the system.
• Do not place the DFS10 near a heat source.
• Do not block or cover the openings on the DFS10. Without adequate ventilation, the
DFS10 may overheat.
• Place the DFS10 in an area that provides adequate space for ventilation and servicing.
• Follow all warnings and instructions marked on, or supplied with, the equipment.
• If the DFS10 does not operate normally, refer to chapter 7, "Problem Solving".
Electrical safety
• Do not use an extension cord. Always connect the DFS10 power cable directly into a
properly grounded power source receptacle. If in doubt, have the receptacle checked
by a qualified electrician.
• Do not use an adapter plug to connect the DFS10 to an electrical outlet that lacks a
ground connection terminal.
• Never override or disable electrical or mechanical interlocks.
• Do not push objects into slots and openings on the DFS10. Making a contact with a
voltage point or shorting out a part could result in a fire or electrical shock.
• If you hear unusual noises or detect strange odors, switch off the DFS10 power
immediately. Disconnect the power cord from the electrical outlet and call a Océ
Service Representative or Customer Support Engineer to correct the problem.
• Do not place the DFS10 where people may walk on the Power Cord or Interface
Cable Cord.
• Do not place objects on the DFS10 Power Cord or Interface Cable Cord.
72 Safety information