Set Up The Interaction Media Server Appliance; Preliminary Hardware Setup; Complete The Windows Server Installation - Interactive Intelligence Audiocodes Mediant 800 based Installation And Configuration Manual

Set up the Interaction Media Server appliance

After you confirm the Interaction Media Server appliance contents, review safety precautions, and
understand where to obtain help and additional resources information, you are ready to set up the
Interaction Media Server appliance.
In this section, you will learn how to:
Perform the preliminary hardware setup
•
• Complete the Windows server OS installation
Locate the Interaction Recovery Module
•
Add the server to the domain
•
• View Network Fault Tolerant (NFT) Network Interface Controller teams
Retrieve the required Interaction Media Server licenses
•
Apply the Interaction Media Server license and the Interaction SIP Proxy Server license
•

Preliminary hardware setup

When the Interaction Media Server appliance arrives, unpack it and connect it to the appropriate
Ethernet network.
1. Unpack the appliance and install it on a rack with monitor and keyboard access.
2. Connect the appliance to the network.
3. Turn on the appliance. The machine runs through a series of installation and system settings
applications and then reboots. The Set Up Windows wizard opens.

Complete the Windows Server installation

This section describes how to run the Set Up Windows wizard and perform other tasks to
complete the Windows Server 2008 R2 operating system installation.
1. Run the Set Up Windows wizard. The system installs applicable devices, applies system
settings, and reboots the machine. When the system reboots, the Set Up Windows dialog
opens.
Interaction Media Server Appliance Installation and Configuration Guide 11