Pro-Form performance 1850 PETL14715.0 User Manual page 35

Locate the Reed Switch (52) and the Magnet (50)
on the left side of the Pulley (49). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet and
the Reed Switch is about 1/8 in. (3 mm). If nec-
essary, loosen the #8 x 3/4" Tek Screw (14), move
the Reed Switch slightly, and then retighten the
Tek Screw. Reattach the Motor Hood (not shown)
with the #8 x 3/4" Screws (not shown) and run the
treadmill for a few minutes to check for a correct
speed reading.
Top
View
52
14
1/8 in.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Calibrate the incline system (see step 4 on
page 31).
SYMPTOM: The iFit mode does not function
correctly
a. If the iFit mode is not functioning correctly, make
sure that the treadmill has the most current firm-
ware available (see step 3 on page 30).
SYMPTOM: The treadmill will not connect to a wire-
less network
a. Make sure that the wireless settings on your con-
sole are correct (see step 4 on page 31).
b. Make sure that the settings for your wireless net-
work are correct.
c. If your wireless network is set to use WEP encryp-
tion, try setting it to WPA or WPA2 encryption
instead.
d. If you still have questions, see the front cover of
this manual.
49
SYMPTOM: The walking belt slows when walked on
50
a. If an extension cord is needed, use only a 3-conduc-
tor, 14-gauge (1 mm
5 ft. (1.5 m).
b. If the walking belt is overtightened, treadmill per-
formance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
35
) cord that is no longer than
2
b
2–3 in.
Idler Roller Screws