Furuno FAR-2807(-D) series Operator's Manual page 107

Alarm name
(visual
indication)
AIS ALARM (See section 4.15.)
DUAL RADAR ALARM (Non-IMO only)
EXT RADAR External radar is in standby
STBY
EXT RADAR External radar malfunction
ERROR
EXT RADAR Problem with heading data at
HDG SET external radar.
OTHER ALARM
ANCHOR Ship has drifted more than a
WATCH threshold value.
ARRIVAL Own ship has arrived to a
waypoint.
CHECK INT-SW Interswitch malfunction
DEPTH Depth is lower or higher than
threshold value.
HEADING SET Heading signal has been
restored.
MEMORY CARD Memory card is full
FULL
TARGET ALARM A target has entered (or exited)
the target alarm zone. Target
flashes.
WATCH WATCH 0:00
(WATCH appears and time count
freezes at 0:00).
XTE Own ship is off course more than
threshold value.
Visual alarm, reason
1. RADAR OPERATION
To quit alarm status
Set external radar in transmit to erase
indication.
Restore external radar to normal
condition to erase indication.
Re-set external radar's heading data
to erase indication.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box. Check
interswitch.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box.
Press the [ALARM ACK] key to erase
the message. Match the on-screen
HDG readout with the actual compass
reading, if necessary.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box.
Press the [ALARM ACK] key or click
the WATCH box with the left button.
The WATCH box is displayed in
normal video and the timer is reset.
Acknowledge indication by pressing
the [ALARM ACK] key or left-clicking
the ALARM ACK box.
1-85