THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
specified.
• The resistance indicated MF shows tolerance 2%.
•
: internal component.
¢
• 1 : fusible resistor.
• 5 : fusible resistor.
• C : panel designation.
Note: The components identified by mark ! or dotted
line with mark ! are critical for safety.
Replace only with part number specified.
• U : B+ Line.
• V : B– Line.
• H : adjustment for repair.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
∗
: Can not be measured.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal pro-
duction tolerances.
• Circled numbers refer to waveforms.
• Signal path.
a
: RF (AC-3)
L : digital in
c : digital out
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
•
: parts mounted on the conductor side.
p
•
: Through hole.
®
•
: internal component.
¢
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A)
parts face are indicated.
1
/
W or less unless otherwise
4
WAVEFORMS
– MAIN BOARD (1/4) –
1
7.17MHz
IC423 %¡ (SCKR)
2
4.18MHz
IC423 $ª (SCKT)
3
3MHz
IC423 @¶ (EXTAL)
4
129kHz
IC201 9 (FL-CLK)
5
16MHz
IC201 2 (XTAL)
6
65kHz
IC301 @™ (LRCK)
7
4.16MHz
IC301 @¡ (BCK)
8
8.32MHz
IC301 @º (FS128)
– 27 –
5.6Vp-p
5.2Vp-p
5.2Vp-p
5.2Vp-p
4.6Vp-p
5.6Vp-p
5.6Vp-p
5.6Vp-p