Paper Does Not Feed Properly/"No Paper" Error Occurs - Canon PRO-100S series Online Manual

Paper Does Not Feed Properly/"No Paper" Error Occurs

Make sure that paper is loaded.
Check1
Loading Paper
Make sure of the following when you load paper.
Check2
In the rear tray:
• When loading two or more sheets of paper, flip through the paper before loading.
• When loading two or more sheets of paper, align the edges of the sheets before loading.
• When loading two or more sheets of paper, make sure that the paper stack does not exceed the paper load
limit.
However, proper feeding of paper may not be possible at this maximum capacity depending on the type of
paper or environmental conditions (either very high or low temperature and humidity). In such cases, reduce
the sheets of paper you load at a time to less than half of the paper load limit.
• Always load the paper in portrait orientation, regardless of the printing orientation.
In the manual feed tray:
When you load the paper, load one sheet at a time. When you print continuously, set the next paper after the last
one is finished printing.
Check to see if the paper you are printing on is not too thick or curled.
Check3
Media Types You Cannot Use
Make sure of the following when you load Hagakis or envelopes.
Check4
• If a Hagaki is curled, it may not feed properly even though the paper stack does not exceed the paper load
limit.
Load Hagakis with a zip code column downward.
• When printing on envelopes, refer to
Once you have prepared the envelopes, load them in portrait orientation. If the envelopes are placed in
landscape orientation, they will not feed properly.
Confirm that the media type and the paper size settings correspond with the
Check5
loaded paper.
Loading Paper, and prepare the envelopes before printing.
493