Samsung CLX-FIN40S Service Manual page 121

● Code : H2-2513
● Symptom :
Stacker operation is abnormal.
● Troubleshooting method :
Are the stacker upper limit sensors working? (Perform diagnostic routine 116-5120, 116-5430)
YES / NO 1. Check if the sensor actuator is working.
2. Check if the connector of the sensors are disconnected.
3. Check if the connector P4 on the finisher main board is disconnected.
4. Check the harness continuity and replace it if required.
5. Replace the stacker upper limit sensors.
6. Replace the finisher main board.
Is the stacker bottom limit sensor working? (Perform diagnostic routine 116-5110)
YES / NO 1. Check if the connector of stacker bottom limit sensor is disconnected.
2. Check if the connector P4 on the finisher main board is disconnected.
3. Check the harness continuity and replace it if required.
4. Replace the stacker bottom limit sensor.
5. Replace the finisher main board.
Is the stacker encoder sensor working? (Perform diagnostic routine 116-5440)
YES / NO 1. Check if the connector of stacker encoder sensor is disconnected.
2. Check if the connector P16 on the finisher main board is disconnected.
3. Check the harness continuity and replace it if required.
4. Replace the stacker encoder sensor.
5. Replace the finisher main board.
Is the stacker motor working? (Perform diagnostic routine 116-0140)
YES / NO 1. Check if the connector of stacker motor is disconnected.
2. Check if the connector P16 on the finisher main board is disconnected.
3. Check the harness continuity and replace it if required.
4. Replace the stacker motor.
5. Replace the finisher main board.
Replace the stacker motor gear box.
Service Manual
CLX-FIN40S/CLX-FIN40L
4. Troubleshooting
● Error message : Finisher Error #H2-2513. Please open/close door.
4-16
SAMSUNG ELECTRONICS