Samsung CLX-FIN40S Service Manual page 117

● Code : H2-2386
● Symptom :
Main paddle operation is abnormal.
● Troubleshooting method :
Is the main paddle home sensor working? (Perform diagnostic routine 116-5310)
YES / NO 1. Check if the connector of main paddle home sensor is disconnected.
2. Check if the connector P15 on the finisher main board is disconnected.
3. Check the harness continuity and replace it if required.
4. Replace the main paddle home sensor.
5. Replace the finisher main board.
Is the main paddle motor working? (Perform diagnostic routine 116-0050)
YES / NO 1. Check if the connector of main paddle motor is disconnected.
2. Check if the connector P15 on the finisher main board is disconnected.
3. Check the harness continuity and replace it if required.
4. Replace the main paddle motor.
5. Replace the finisher main board.
Is there any gear jumping noise?
NO / YES 1. Check if the gears are assembled correctly.
2. Check if the main paddle motor bracket assembly is fasten on mold base by screw.
3. Check if the tooth of gears are broken.
Check if the main paddle roller hub is broken.
Replace main paddle module assembly.
Service Manual
CLX-FIN40S/CLX-FIN40L
4. Troubleshooting
● Error message : Finisher Error #H2-2386. Please open/close door.
Replace the hub.
4-12
Replace the broken gears.
SAMSUNG ELECTRONICS