Table of Contents
Advertisement
Tender Light:
1. Remove the six (6) screws that hold the chassis to the body and pull the two
components apart, being careful to leave the wires attached.
2. Unplug the wire from the connector.
3. Unscrew the bracket that houses the light bulb from inside the tender.
4. Gently pull the bulb to remove it and push the replacement into place.
5. Reassemble in reverse order, being careful not to pinch any wires.
Firebox and Cab Interior Lights:
1. Remove the boiler from the engine (see Fig. 7 on pg. 12). Remove the two
front and two rear body mount screws and carefully lift the boiler from the
chassis, being careful to leave the wires attached.
2. Unplug the black wires from their connector. You must change both the
firebox light and cab interior light at the same time.
3. Remove the firebox light bulb by pulling it down and out of its bracket.
You may find it easier to unscrew the bracket from the boiler before removing
the bulb. Replace the bulb by pushing it up and into the bracket. You may
need to use small pliers to do this.
4. Remove the cab interior light by pulling gently on the wire until the bulb
comes free of its housing. Push the replacement bulb into position.
5. Reassemble in reverse order, taking care not to pinch any wires.
Bracket that holds
firebox light
and cab light
Figure 10. Replacing the Firebox and Cab Lights.
15
Premier Dreyfuss Steam Engine
Advertisement
Table of Contents
