Locomotive Light Bulb Replacement - M.T.H. New York MTA R-21 Operating Instructions Manual

Locomotive Light Bulb Replacement

To replace the light bulbs in the locomotive, follow these instructions:
Follow the cab removal instructions found in the "Lubrication and Greasing"
section of this booklet. Once the body has been removed, remove the
lightbulb as shown in Fig. 4 and replace it.
Figure 5. Instructions on the Replacement of the Interior Lights of the Powered Car.
To replace the lights in the non-powered cars, remove the shells from the
chassis by removing the four screws located under the cars (see figure 3 on
page 9) Then, replace the burned out bulb by sliding it out of its place on the
contact board, replace and re-assemble the car (see figure 6 below).
You can obtain replacement bulbs directly from the M.T.H. Parts Department.
Figure 6. Replacing the lights in the Non-Powered car.
11
RailKing R-21 4 Car Subway Set