Table of Contents
Advertisement
Lubrication and Greasing Instructions
The engine should be well oiled and greased in order to run properly.
You should regularly lubricate all side rods and linkage components and
pickup rollers to prevent them from squeaking. Use light household oil and
follow the lubrication points marked "L" in Fig. 6. Do not over-oil. Use only
a drop or two on each pivot point.
Figure 6. Lubrication Points on the Locomotive
The locomotive's internal gearing was greased at the factory and should not
need additional grease until after 50 hours of operation or one year, whichever
comes first. To access the gear box, do the following:
1. Turn the engine upside down.
2. Remove the Phillips screws (marked "GREASE") located at each set of
wheels.
3. Use a grease tube dispenser to put a small amount (approx. 1-2 ml.) of
lithium-based grease into the gearbox.
4. Replace the screw.
You should also grease the leading and trailing locomotive truck tongues to
enhance their ability to slide on the chassis. Follow the grease points shown on
Fig. 7.
Periodically check the locomotive wheels and pickups for dirt and buildup,
which can cause poor electrical contact and traction as well as prematurely
wear out the neoprene traction tires.
Body Mounting Screws
Lubricate Pivot Point (G)
Figure 7. Location of Body Mount Screws and Greasing Points on the Locomotive
Premier Dreyfuss Steam Engine
Lubricate Side Rods and Linkage (L)
Lubricate Pick Up Rollers (L)
Grease Screw (G)
12
Body Mounting Screws
Advertisement
Table of Contents
