Table of Contents
Advertisement
Light Replacement Instructions
The locomotive's lights are controlled by a constant voltage circuit in the
engine. They are easy to remove and replace when they burn out. See the
diagrams and directions below for instructions on accessing and replacing the
light bulbs in this locomotive.
You can obtain replacement bulbs directly from the M.T.H. Parts Department
(phone: 410-381-2580; e-mail: parts@mth-railking.com; mail: 7020 Columbia
Gateway Drive, Columbia MD 21046-1532)
Headlight:
1. Remove the boiler from its chassis as shown in Figure 7 on pg. 12.
2. Gently pull the wires connected to the lights out until you can access the
wire connectors, and unplug the connectors.
3. To replace the white headlight, gently pull the wires until the bulb comes
free of the housing. Push the new bulb into place and reconnect the wires.
4. Gently push the wires back into the boiler body and reassemble the boiler,
being careful not to pinch any wires.
Figure 8. Changing the Headlight.
Premier Dreyfuss Steam Engine
Unplug wires
from harness
14
Unscrew light bracket
Figure 9. Changing the Tender Light.
Unplug wire
from connector
Advertisement
Table of Contents
