Table of Contents
Advertisement
Message
34 Incorrect Media
34 Short Paper
35 Res Save Off
Deficient Memory
36 Printer Service
Required
37 Insufficient
Collation Area
37 Insufficient Defrag
Memory
What this message means
The printer has detected a mismatch in
the requested media type and the type
loaded in the multipurpose feeder or
any tray.
See "Paper and specialty media
specifications" on page 39 for more
information.
The printer has determined that the
length of the paper in the source
specified on the second line of the
display is too short to print the
formatted data. For auto-size sensing
trays, this error occurs if the paper
guides are not in the correct position.
The printer lacks the memory needed
to enable Resource Save. This
message usually indicates too much
memory is allocated for one or more of
the printer link buffers.
Background toner has prevented a
calibration cycle from completing. A
defective cartridge or ITU may be
installed. Contact a service
representative for a diagnosis.
The printer memory (or hard disk, if
installed) does not have the free space
necessary to collate the print job.
The printer cannot defragment flash
memory, because the printer memory
used to store undeleted flash
resources is full.
83
What you can do
• Replace the media in the multipurpose
feeder or tray with the requested media
and press Go.
• Press Menu to access the Busy/
Waiting Menu group, and select one of
the following options:
– Cancel Job
– Reset Printer
– Reset Active Bin
– Check Supply Levels
• Press Go to clear the message and
continue printing. The printer does not
automatically reprint the page that
prompted the message.
• Make sure the Paper Size setting in the
Paper Menu is correct for the size paper
you are using. If MP Feeder Size is set
to Universal, make sure your paper is
large enough for the formatted data.
• Press Menu to open the Job Menu and
cancel the current job.
See also:
Paper and specialty media
specifications
• Press Go to disable Resource Save and
continue printing.
• To enable Resource Save after you get
this message:
– Make sure the link buffers are set to
Auto, and exit the menus to activate
the link buffer changes.
– When Ready is displayed, enable
Resource Save from the Setup Menu.
• Install additional memory.
Press Go to clear the error.
See also:
Calling for service
• Press Go to print the portion of the job
already stored and begin collating the
rest of the job.
• Press Menu to open the Job Menu and
cancel the current job.
See also:
Canceling a print job
• Delete fonts, macros, and other data in
printer memory.
• Install additional printer memory.
Advertisement
Table of Contents
