Table of Contents
Advertisement
Message
Held Jobs May Not Be
Restored
Hole Punch Waste Full
Insert Staple Cartridge
Insert Tray <x>
Install <device> or
Cancel Job
Invalid Engine Code
Invalid Network <x>
Code
Invalid Standard
Network Code
ITU/Fuser Maint
Load Manual
Load <x> Plain Letter
What this message means
The printer memory cannot restore
Print and Hold jobs from the printer
hard disk.
The hole punch box in the finisher is
full.
The staple cartridge in the finisher is
missing or is installed incorrectly.
The specified tray is either missing or
not fully inserted.
The printer is requesting that a
specified device be installed so it can
print a job.
The printer engine code has not been
programmed or is not valid.
The code in an internal print server is
not valid. The printer cannot receive
and process jobs until valid code is
programmed into the internal print
server.
The counters that track wear on the
image transfer unit and fuser have
reached their limit.
A request for a manual feed job has
been sent to the printer. The printer is
ready for insertion of a single sheet
into the manual feed slot.
Someone has initiated a tray
calibration procedure.
What you can do
Press Go to clear the message. Some of
the Print and Hold jobs stored on the disk
will not be restored.
See also:
Empty the hole punch box.
• Correctly install the staple cartridge to
clear the message.
• Press Go to ignore the message and
continue printing without stapling.
Insert the specified tray completely into the
printer.
See also:
• Turn the printer off, install the specified
device, and restart the printer.
• Press Menu to open the Job Menu and
cancel the current job.
Call for service.
See also:
Download valid code to the printer internal
print server.
Note: You can download network code
while this message is displayed.
Replace the image transfer unit and fuser.
See also:
the image transfer unit and transfer
roller
• Load a sheet of the paper specified in
the second line of the display in the
manual feed tray or multipurpose feeder.
• Press Select or Go to ignore the manual
feed request and print on paper already
installed in one of the input sources. If
the printer finds a tray that has paper of
the correct type and size, it feeds paper
from that tray. If the printer cannot find a
tray with the correct paper type and size,
it prints on whatever paper is installed in
the default input source.
• Press Menu to open the Job Menu and
cancel the current job.
See also:
feeder
Load paper into <x> and press Go to
continue the calibration process.
77
37 Insufficient Memory
Loading the trays
Calling for service
Replacing the
fuser;
Replacing
Loading the multipurpose
Advertisement
Table of Contents
