Configuration - Kettler Atmos Pro Instruction Manual

Configuration - User controls
19 12 11
17 18
16 15 14 1 7
1 Stop button
2 Start button
3 Set button
4 Safety key
5 Slow button
6 Fast button
7 Play/Pause button
8 Sound+/Next button
9 Sound-/Last button
10 Program button
11 LCD screen
12 Easy speed button combination
13 Easy speed button combination
14 Down incline (button)
15 Up incline (button)
16 USB / Headphone
17 Item holder
18 Speakers
19 Mute button
LCD brightness adjustment
1. Make sure all the screen displays are showing 0 by doing
a quick start / stop.
2. Press and hold the STOP button for 5 seconds until you
see the incline display change to 20%. By using the FAST
or SLOW buttons you can adjust the brightness.
3. Press the START button to save your brightness setting.
13
18
8 9 2 10 5 3 6 4
Testing the Treadmill Operation
Use the following instructions to test the full speed of the
treadmill and to check the belt for proper operation.
17
Kettler recommends that the treadmill is unplugged or the
on/off power (I/O) is switched off (O) when not in use.
1. Without anyone on the machine, plug the treadmill.
Ensure the power cord is not being pinched under the
front of the treadmill.
2. Locate the on/off (I/O) power switch under the front end
of the treadmill. Switch it to the on position (I). The control
panel will light up.
3. The weight digits will flash. Adjust the weight using the
SPEED button located on the handrail.
4. Press START button and the motor will work at the speed
of 0.3 km/h. Check if the monitor is working normally.
5. Observe the belt to see if it is running properly; it should
be centred in the middle of the deck. If you have problems
with the running belt operation, see
Adjust Running Belt in the
Preventive Maintenance chapter.
6. Press the FAST and SLOW
button to check whether they are
working. Run the treadmill through its full speed range.
First press the FAST button
until the treadmill reaches its
highest speed. Then press the
SLOW button until the treadmill is back to 0.3 km/h.
7. Press the STOP button and check if the machine stops
working.
When folding the treadmill please
ensure thet the incline is set to
Warning
Zero.
11