Mounting And Connections - Cobra 75 ST EU Operating Instructions Manual

Installation
Mounting and

Mounting and Connections

Connections
The Transceiver is held by two screws, permitting mounting in the
manner most convenient for your installation.
Mounting hardware is supplied for mounting the Transceiver. The
mounting must be mechanically strong and also provide a good
electrical connection to the chassis of the vehicle. Proceed as
follows to mount junction box:
1 After you have determined the most convenient location in your
vehicle, hold the Cobra 75 ST EU Transceiver in the exact
location desired. If nothing will interfere with mounting it in the
desired position, use the Transceiver as a template to mark
the location for the mounting screws. Before drilling the holes,
make sure nothing will interfere with the installation of the
mounting screws.
2 Connect the antenna cable connector to the antenna
receptacle on the unit. Most CB antennas are terminated with
a type PL-259 plug and mate with the receptacle.
3 Connect the control unit to the front connector.
4
1 Connect to 12V Dashborad Connection.
2 For constant 12 volt source power, remove the cigarette lighter
plug and connect the red wire marked "BATT(+)" directly to the
positive side of the battery or to a connection on the fuse block
that is always on.
3 Connect the black wire "Ground" to the negative side of the
car, usually the chassis. Any other location with good electrical
contact (paint removed) will also work.
Installation
Mounting and
Connections
Caution
Leaving the 75 ST EU on after
your car is turned off can drain
your car battery when connected to
a constant 12 volt source. When
connected to an accessory 12 volt
source the unit will turn off when
vehicle is turned off.
5